2.
Introduction
2.1.
Features
•
The use of
LTE, NB-IoT
by Surf-K and
LTE, CAT-M1
by Surf-KM, makes them
capable of covering a wide area using low power cellular technology.
•
Line capture
allows Surf-K and Surf-KM to detect and capture
CID and SIA
events
and monitor any alarm system that uses these formats.
•
Keybus
allows Surf-K and Surf-KM to communicate with the Keypad in a faster
way. Also giving the possibility of having troubles showing on the Dashboard in
case of any unforeseen event.
•
In case the panel doesn’t support Keybus, Surf-K and Surf-KM can use 3 input
zones to
monitor generic alarm
outputs of the panels by providing generic
Burglary, Fire, and Panic inputs to monitor these systems.
•
In case a panel doesn’t support Keybus, Surf-K and Surf-KM could also use
Tip/Ring –
Key Switch Arming
to arm and disarm your system.
•
Surf-K and Surf-KM display
Full Event Reporting
when connected to Aryo Cloud.
•
Zone & Partition
Status are shown on the platform, assigned by the Dealer.
•
OTA Firmware Updates
are provided in real time, keeping your system up to date.
•
Connected to Aryo Cloud, Surf-K & Surf-KM will provide
Automatic Status
Detection
, disclosing in real time the status of the connection, network, voltage,
etc.
2.2.
Surf codes
Surf-K and Surf-KM uses one master code (for main user) and 40 user codes to arm and
disarm the host control panel when keyswitch arming is used or If Keybus connection is not
used or available. These Codes are different from the host control panel Master and User
Codes. If SURF-K or Surf-KM master code is lost, it can be reprogrammed by the Dealer.
2.3.
Monitoring options
2.3.1.
Tip/Ring monitoring–
Is used to
connect to panel
TIP
and
RING
terminals for
detection and capture of CID and SIA format events. These signals are sent to Aryo
cloud and the monitoring center.
2.3.2.
Keybus monitoring –
is used to connect to DSC power series keybus
Yellow
and
Green
terminals to fully interact with panel keybus communication. The events and
status signals are sent to Aryo cloud and the monitoring center.
2.3.3.
Keybus and Tip/Ring monitoring -
Are used to
connect to panel
TIP
and
RING
terminals for detection and capture of CID and SIA format events and to connect to
DSC power series keybus
Yellow
and
Green
terminals to fully interact with panel
