48
REV. 09/2020
49
REV. 09/2020
STEERING SYSTEM
STEERING SYSTEM
5
5
Quality of tyres directly affects the stability and
driving performance of the device.
If you need to replace the factory-fitted tyres,
please use original spare parts provided by the
equipment manufacturer to reach the original
design performance of the truck.
CAUTION
-
Turn the wheel to see if it is rotating smoothly,
and if there is blocking or not;
-
Run the truck to see if the steering wheel is
functioning properly. If there is blocking or
noise, please check if the wheel bearings are
functioning properly.
5.2 Steering Bridge
5.2.1 Removal and Installation
Removal
Installation
-
Install according to the reverse order of rem-
oval.
-
Turn off the truck power and remove the key;
-
Dismantle the rear steering wheels; (
-
Remove the two tubings (1) from the steering
bridge;
-
Unscrew the four bolts (2) and remove the fix
plate (3), then dismantle the steering bridge
(5) from the chassis;
-
Remove the two damping pads (4) from the
steering bridge (5).
When removing the tubing and steering bridge,
the system will lose some hydraulic oil, please
of hydraulic oil.
CAUTION
Before going on with the next step, please
fix the steering bridge properly first. Be sure
to avoid the falling of steering bridge during
removal, resulting in personal injury.
CAUTION
Hydraulic oil may damage truck parts and cont-
aminate the environment. When removing joints
or tubings, place a clean container under it for
discharge of hydraulic oil.
CAUTION
Please add grease (see
for specifica
-
tion ).
5.2.2 Component
Be sure to bend a cotter pin.
No.
Name
No.
Name
No.
Name
No.
Name
1
Hub Cover
7
Steering Knuckle 13
Bearing
19
Oil Cup
2
Cotter Pin
8
Gasket
14
Bolt
20
Connect Rod
3
Nut
9
Bearing
15
O-ring
21 Steering Cylinder
4
Bearing
10
Sleeve
16
Bearing
22
Axle Body
5
Hub
11
Pin
17
Scraper Seal
23
Space Plate
6
Seal
12
Check Ring
18
Master Pin
24
Bolt