36
• Clean the battery, grease the terminals and connect the battery.
• Charge the battery (See 4.4 Charging the battery P23).
• Check hydraulic oil for condensed water and replace if necessary.
• Run the truck (see 3.3 Run the truck P15).
Battery powered trucks:
If there are switching problems in the electrical system, apply contact spray to the
exposed contacts and remove any oxide layers on the contacts of the operating
controls by applying them repeatedly.
Perform several brake tests immediately after re-commissioning the truck.
5.5 Safety checks to be performed at regular intervals and following any
unusual incidents
Carry out a safety check in accordance with national regulations. We have a special
safety department with trained personnel to carry out such checks. The truck must be
inspected at least annually (refer to national regulations) or after any unusual event by
a qualified inspector. The inspector shall assess the condition of the truck from purely
a safety viewpoint, without regard to operational or economic circumstances. The
inspector shall be sufficiently instructed and experienced to be able to assess the
condition of the truck and the effectiveness of the safety mechanisms based on the
technical regulations and principles governing the inspection of trucks.
A thorough test of the truck must be undertaken with regard to its technical condition
from a safety aspect. The truck must also be examined for damage caused by
possible improper use. A test report shall be provided. The test results must be kept
for at least the next 2 inspections.
The owner is responsible for ensuring that faults are immediately rectified.
A test plate is attached to the truck as proof that it has passed the safety inspection.
This plate indicates the due date for the next inspection.
5.6 Final de-commissioning, disposal
Final, proper decommissioning or disposal of the truck must be performed in
accordance with the regulations of the country of application. In particular, regulations
governing the disposal of batteries, fuels and electronic and electrical systems must
be observed.
Summary of Contents for 508000003143
