EOS P 396, Training Manual

Page: 79 / 170

Part Property Management
5.9
Training manual • Basic training • Status 03.14
EOS P 396
5
Exposure types for the PPP parameter sets
There are six exposure types available in the individual PPP parameter sets.
➢ Exposure type EOS
The exposure type EOS is, as a standard exposure type optimised for complex
design data at high building speed, suitable for approx. 90 % of all applications.
By using the exposure function Edge, thin wall thicknesses (< 2 x value of the
beam offset) are also exposed with this exposure type. In certain circumstances,
radii and edges are however built with coarser steps. This situation is dependent
on the shape and the building position of the parts.
➢ Exposure type EOS_noEdge
Unlike the exposure type EOS , with the exposure type EOS_noEdge thin wall
thicknesses that are less than twice the beam offset are not exposed. In certain
circumstances, radii and edges are however built with finer steps.
A B
A Part with exposure type EOS_noEdge B Part with exposure type EOS