36
Installation and Operating Instructions - MEGA
Maintenance
EN
Replacing sauna stones
1
CAUTION! Caution: stones may be hot. Allow the stones to cool for at
least 45 minutes before you remove the old stones.
Remove each stone individually.
2
Check each stone for damage. Sort out any stones with severe damage.
3
Rinse the stones with cold water.
4
Stack the stones loosely in the rock store leaving sufficient space be-
tween them.
6.3 Replacing the tubular heating elements
You can replace individual tubular heating elements or the entire heating
coil. One heating coil is installed on each long side of the heater. The pro-
cess for dismantling the heating coils is identical on each side.
If the heater is too close to the wall, it may be necessary to move it so that
you can access the rear side. To move the heater more easily, remove
stones.
The following steps must be carried out:
Necessary steps:
Replacing the tubular heating elements,
Ha tools:
Tubular heating element and/or heating coil
Screwdriver
Hex key SW 5
Ring or socket spanner SW 22
