4
Call 1300 369 273
www.enware.com.au
installation
1. Set out and Rough-in:
Provide a 1/2” BSP male fitting for water inlet,
allowing approximately 12mm of thread proud
from finished wall.
2. Prior to installation, flush the line thoroughly
to remove debris. Once the line is clear of
debris, proceed to next step. A pressure
reduction valve may be required to comply
with recommended water supply pressure.
3. Apply thread tape onto the 1/2” BSP male
thread on wall. Screw wall mount on and
tighten firmly.
4. Apply thread sealing tape onto male thread of
chrome elbow and screw to wall mount firmly.
A 1/2” BSP male fitting can be screwed on
loosely to the other side of the elbow to gain
leverage and tighten with a spanner. Ensure the
elbow is facing straight down.
5. Apply thread sealing tape onto thread of hose
assembly, and screw onto the elbow with a
spanner.
6. Locate the bracket, and once the hand held eye
wash is in the desired position, mark holes for
the bracket on wall. Drill the holes and secure
bracket using appropriate wall fixings/ anchors.
7. Turn water supply on and test all joints and
connections for leaks. Grab the trigger gun and
squeeze the handle to test for correct operation
and water flow. If there is any problem refer to
Troubleshooting on page 6.
8. Hook the hand trigger gun onto bracket.
Flip the outlet cap back on so no dust
accumulates on the outlet. Installation is
now complete.
34
6 mm
17
42
Holes on
Bracket