12
AlcoQuant® 6020 – Breathalyser – Operating Instructions
After pressing “Print”-Button
a measurement report will be printed by an attached Printer
(optional accessory).
If the measured value is above of the measurement range (0-5,5
‰)
the display shows the
following message:
Additional it is signalised acoustically by a short dual signal and optically by the red LED.
6.2.3
6.2.3
6.2.3
6.2.3
Printing of measurement values
ing of measurement values
ing of measurement values
ing of measurement values
Press the “Print”-Button while the measured value is shown (Section 6.2.2 and 8.1) a
measurement report will be printed by an attached Printer (optional accessory).
ATTENTION:
After the „Print“-Button has been pressed the device not responds to any keypress for approx. 5sec. In this time the device
sends the data to the connector.
6.2.4
6.2.4
6.2.4
6.2.4
Further measurements
Further measurements
Further measurements
Further measurements
After briefly pressing the “OK” key
the device is prepared for the next measurement and
the sensor system is rinsed. Thereafter the procedure is the same as the sequence in Section
6.2.2.
6.3
6.3
6.3
6.3
How to switch off the AlcoQuant® 6020
How to switch off the AlcoQuant® 6020
How to switch off the AlcoQuant® 6020
How to switch off the AlcoQuant® 6020
The “ON/OFF” key
must be pressed for approximately 3 sec. to switch off the AlcoQuant®
6020. The device then switches off.
ATTENTION:
If no measuring procedure is carried out within 2.5 minutes of the device becoming ready to operate, the AlcoQuant®
6020 switches off automatically.
ATTENTION:
The background lighting of the display switches off automatically after 15 sec. and is reactivated by pressing any key.
When the background lighting is switched off the first press of a key is used to switch the lighting on and does not affect
the menu navigation.