Envipco U48DFF, Service Manual

Page: 47 / 100

4-1
Chapter 4
RVM Software
4.1. Introduction
The
ULTRA
series introduces new software and electronics hardware to Envipco’s
RVM
s. There are three
software modes on the
ULTRA
: Customer/Acceptance Mode, Shop Mode, and Service Mode.
•
Customer/Acceptance Mode - This refers to the software that runs and displays
information while the cabinet doors are closed and the machine is ready to accept
containers or while the machine processes containers. In this mode, the screen dis-
plays instructions to the user and may show videos.
•
Shop Mode - Shop Mode can be configured to start automatically when the cabi-
net door is opened. It can also be configured to require a
PIN
. Once in this mode,
store personnel may review machine information, re-print a receipt, and clean the
In-Feed conveyors and rollers.
•
Service Mode - This mode starts once the technician logs into the
RVM
using a
USB
drive and
PIN
. In this mode, the technician may complete in-depth service
and maintenance tasks on the
RVM
. Service Mode comprises three components:
•
Technician Interface
•
Diagnostic Program
•
Configuration Editor
4.2. Shop Mode
Figure 4-1 shows the Shop Mode screen. This mode allows store personnel and technicians to do the
following tasks without having to log in to Service Mode:
•
Toggle Info Window - shows information about the
RVM
.
•
Re-print Last Receipt - reprints the last customer receipt.
•
Cleaning Mode - runs the rollers and the In-Feed and Sorter conveyor belts to
facilitate cleaning.