2
3
240
safeTy insTrucTions
imPorTanT warnings
SAvE THESE INSTRUCTIONS
WARNING: RISK OF ELECTRICAL SHOCK
Safety precautions should always be used when operating this or any electrical appliance.
Decrease the risk of electrocution, electric shock, injury or fire by reading and following all the
warnings below.
Use only as described in this Therapure
®
manual. To reduce the risk of electric shock, do
not attempt to service the product in any way other than in the manner described in the
“Cleaning & Maintenance”
section of this manual.
READ ALL INSTRUCTIONS BEFORE OPERATING THE AIR PURIFIER.
»
This product operates at 120V AC, 60Hz only.
»
Do not run power cord under carpets, and do not cover with throw rugs.
»
Do not operate the product in any greasy environment, such as in the kitchen. This product is
not intended to filter oil or grease from the air.
»
Do not use the Therapure
®
240 air purifier in bathrooms or other humid environments. Do not
use near fireplaces or in areas where flammable or combustible vapors or products may exist.
»
Always unplug the power cord from the electrical outlet when the purifier is not in use, before
cleaning, inserting or removing parts or before moving to another location.
»
Never run the air purifier unless it is fully assembled.
»
To reduce the risk of electric shock, this product has a polarized plug (one blade is wider than
the other). This plug will fit into a polarized outlet only one way. If the plug does not fit into the
outlet, contact qualified service personnel to install the proper outlet. Do not alter the plug in
any way.
»
Always turn off all controls before unplugging the Therapure
®
240 air purifier from the outlet.
»
Attempting to service the Therapure
®
240 air purifier in any way that is not described in this
owner’s manual will cause the warranty to be voided and could cause serious personal injury
to the user and/or result in considerable damage to the unit.
»
Do not place the cord near a heated surface.
»
Never operate the Therapure
®
240 if the plug or cord is damaged or appears damaged. Only
qualified service personnel should replace or attempt to replace a damaged power cord.
»
Never use the power cord to pick up, carry, drag, pull, or lift the Therapure
®
240 air purifier.
Do not pull the cord against or around sharp corners and edges. This could result in injury to
the user or damage to the cord.
»
Always remove the plug from its power outlet by holding onto the plug itself and pulling gently.
»
Never pull on the cord itself to unplug it from its power outlet.
»
Use care when operating the Therapure
®
240 air purifier by keeping all foreign objects, fingers,
body parts, hair, loose clothing and jewelry away from openings.
»
Never touch the Therapure
®
240 air purifier or its plug when your hands are wet.
»
The Therapure
®
240 air purifier is an electrical appliance. Adult supervision is required when
operating the Therapure
®
240 in the presence of children.
»
To reduce the risk of fire or electric shock, do not use this air purifier with any solid-state speed
control devices.
Uv Lamp Notice
UV Light is harmful to bare skin and eyes and can cause temporary or permanent loss of vision.
Never look directly at the UV lamp while it is illuminated; doing so could cause loss of vision!
Only view illumination through the window at the front of the unit. To prevent exposure to
ultraviolet light, disconnect the power to the unit before servicing any part of the Therapure
®
240
air purifier.
Mercury Notice
This device contains mercury in the sealed ultraviolet lamp(s). Do not place your used lamp(s) in the
trash. Disposal of any item containing mercury must be in accordance with any hazardous waste
disposal or recycling laws and regulations of your state.
Uv Lamp Disposal
If the UV lamp breaks, turn off the unit. Do not operate the unit with a broken lamp. Do not use a
vacuum to clean up breakage. Sweep debris into a plastic bag and dispose of properly. Contact your
local waste management authority for instructions regarding recycling and the proper disposal of
old lamp(s). To order a replacement lamp, call
1.800.875.8577
or go to
www.envionproducts.com
.
