12
13
TA500
TA500
With very little effort, the Ionic Pro® Turbo ionic air purifier delivers cleaner, fresher, healthier air
to your indoor environment. Keep your Ionic Pro® Turbo ionic air purifier functioning properly by
cleaning the collection blades after every month of use as recommended. The internal ionizing wires
are an important part of the Ionic Pro® Turbo ionic air purifying system and need to be cleaned at the
same time or whenever you hear excessive noise. (See “TO CLEAN IONIZING WIRES” and “DEEP
CLEANING”sections.)
More frequent cleaning may be required if your Ionic Pro® Turbo ionic air purifier is new or if you place
it in a different location. Exposing your Ionic Pro® Turbo ionic air purifier to candle/oil lamp/fireplace
soot and smoke is not recommended and will require the collection blades to be cleaned after every
exposure. (See “IMPORTANT WARNINGS”.)
HELPFUL TIPS: Remember to clean the collection blades and ionizing wires on your Ionic Pro® Turbo
air purifier every month and anytime the red CLEAN/FAULT light comes on or whenever you hear
your unit begin to make excessive noise.
Do not attempt to remove any other internal parts or disassemble the unit. This may cause
serious injury and could damage the unit.
To Clean the Collection Blades:
1. Turn off and unplug your Ionic Pro® Turbo
ionic air purifier.
2. Let the unit rest a minute before attempting
to remove the collection blades.
3. Pull upward on the release latch of the
collection blade unit and pull out from the
main door.
4. Remove the collection blade unit.
5. Do not touch the metal blades until after
discharging residual electricity by touching
blades to an electrical ground such as a
water pipe or metal faucet.
6. Wipe away the trapped particles collected on
the three blades with a slightly damp sponge
or cloth.
7. IMPORTANT: To avoid damaging your Ionic Pro®
Turbo ionic air purifier, make sure the blades are
completely dry and free of all moisture and that
your Ionic Pro® Turbo ionic air purifier is turned off before re-insertion. If you used a slightly damp
cloth to clean the blades, it is possible the collection blades will be completely dry within two to
three hours.
READ THIS: To avoid damage, please make sure that all surfaces and edges of the
collection blades are thoroughly dry before re-inserting them into your Ionic Pro® Turbo
ionic air purifier.
CLEANING & MAINTENANCE
CLEANING & MAINTENANCE
If dust accumulates inside the door of the
air purifier, please follow these instructions
to clean.
1. Turn off and unplug your Ionic Pro®
Turbo air purifier.
2. Open the door and remove the
collection blades.
3. Use the soft brush hose attachment to vacuum
out the dust. Do not use liquids to clean.
To Clean the Internal Ionizing Wires:
There is an internal wire cleaner that cleans the
internal ionizing wires by sliding up and down to
scrape off particle residue.
1. Gently pull the lever up and down
several times.
2. The internal ionizing wires need to be
cleaned after every four weeks of use.
