OCTO MK2 (71521)
Visit the ENTTEC website for the latest version.
..
USER MANUAL
14
|
ID: 5928937
Document Updated: October 2022
Netmask is set to 255.255.255.0
Input protocol is set to Art-Net
Output pixel protocol is set as WS2812B
Pixel colour is set to RGB
Both ports are set to output 4 universes. The start universe for output 1 & output 2 is set as 0
Mapped pixels value is set to 680 pixels
DMX start address is set to 1
APA-102 and TM1814 global intensity set to maximum
Resetting via Web Interface
The ‘Reset to Defaults’ command can be found under the Settings tab of the OCTO MK2’s local hosted web
interface.
Once the command is pressed, a pop-up would appear as shown in the image below:
Resetting by Reset Button
The reset button on the device restores the network configuration of the OCTO MK2 to factory defaults. To
reset to factory defaults, the following procedure must be performed:
1.
Power off the unit.
2.
Press and hold the Reset button.
3.
While holding the Reset button, power up the unit, and keep holding the button for approximately 3
seconds until the LED starts blinking red.
4.
Release the Reset button.
5.
Power cycle the unit.
Frequently Asked Questions
I’m unable to connect to the
OCTO MK2 web interface.
Ensure that the OCTO MK2 and your computer are on the same subnet.
To troubleshoot:
1.
Connect the OCTO MK2 directly to your computer using a Cat5 cable and power it on.
2.
Give your computer a Static IP address (e.g.: 192.168.0.20).
3.
Change computer Netmask to (255.255.255.0).
4.
Open ENTTEC EMU software.
