Entrust nShield Solo, Installation Manual

Page: 41 / 49

a. Datastore:
<datastore1>
b. Available space (GB):
<357.3>
c. Virtual disk size:
50 GB
d. Select the radio button for
Thick Provisioned Lazy Zeroed .
10. Select
Next .
11. Select
Edit the virtual machine settings before completion .
12. Select
Continue .
13. Select
Add .
14. Select
PCID .
15. Select
Next .
16. Select the configured PCI passthrough device.
For example, 02:00.0 will be Freescale Semiconductor Inc <class> Power PC .
17. Select
Next .
18. Select
Finish .
C.4. XenServer environments
Install the XenServer, follow the instructions in the Citrix XenServer Quick Start Guide.
see https://docs.citrix.com/en-us/xenserver .
C.4.1. Configure the XenCenter client
To remotely manage VM guests and configure PCI passthrough of the nShield Solo XC:
1. Enter the XenServer web client IP address.
2. Select
XenCenter installer . The XenCenter software will auto install.
3. Select the XenServer that you want to connect to and manage from the Resources
pane. A connection is established providing access to all the VMs installed on the
server.
4. Select the
Console tab from the Properties tabs pane.

Dom0 is the initial domain started by the Xen hypervisor on boot.
Dom0 runs the Xen management toolstack and is has direct access
to the hardware. Dom0 provides Xen virtual disks and network
access for VM guests, each VM guest is referred to as a DomU (i.e.,
unprivileged domain).
5. Run the command lspci
.
nShield® Solo and nShield® Solo XC Installation Guide 41 of 49