Entrust Artista CR875, Installation And Administrator'S Manual

Page: 29 / 150

CR825 and CE875 Instant Issuance System Installation and Administrator’s Guide 19
c.
When the code is correct, press E
NTER
to apply the code.
When the system activation is successful,
Request
Success
displays briefly on line 2 of the LCD panel
and the U
SER
light glows steady green. The LCD
panel then displays
Ready
to show that the printer
has been activated.
If another message displays on line 2, system
activation failed. Repeat the activation process. If activation fails again, contact Entrust
Datacard technical phone support at 1-800-328-3996.
Clean the Printer
The first time you set up the printer, run an isopropanol cleaning card through the newly installed
printer to remove any dust that might have collected during shipping or storage.
1.
Open the ink ribbon container and remove the isopropanol
cleaning card package.
2.
Open the isopropanol cleaning card package and remove the
card.
Clean the printer immediately. The cleaning card dries out if it is
out of its package for more than a few minutes.
The printer ships with two types of cleaning cards:

An isopropanol cleaning card, included in each ink ribbon package.

A 10-pack of adhesive cleaning cards.
Refer to the cleaning schedule in the printer’s
User’s Guide
for information about
when to use each type of cleaning card.
The cleaning card may become bowed slightly during
shipment. If the card is bowed, insert the card into the
printer as shown.
Isopropanol
Cleaning Card
Card Without Bow
Card With Bow