ADVANCED FEATURES
Multi-weld Operations
178 |
P a g e
Copyright © 2021 BF ENTRON and/or its affiliates. All rights reserved
Product Model:
iPAK2v2
Firmware Version:
V2.10
May 22 | Doc No 700253-2
9.7.1.1
Transformer Assignment
The Features configuration parameter must be set to
Extended
for the
Transformer
parameter to be programmable.
shows the location of the Features parameter in NetFlash™.
Refer to the Configure the Control
section for
configuration instructions.
Figure 51: Location of Features Parameter in NetFlash
Each
Electrode
must be assigned to a
Transformer
. In other words, a one-to-one relationship must be defined between
the electrode and transformer.
Electrode
Parameter
Range
Description
NetFlash Screenshot
Transformer
0 - 7
The transformer that the
electrode is connected to
Table 64: Transformer Parameter in Electrode Settings
In NetFlash™, the
Transformer
parameter is located on the
Electrode
tab. The transformer must be defined with each
electrode. The transformer-electrode assignment can also be set via WSP3, MODBUS, or EtherNet/IP.
Figure 52: Transformer Parameter in Electrode Settings
Multi-Electrode Machine
For Multi-Electrode configurations with a
single transformer
, the Transformer number
should be the same for all electrodes. Refer to the Configure the Control
section for
more information on configuration.
shows how the electrodes can be assigned to transformers/SCRs.
