Enterasys SecureStack C2, Configuration Manual, Page: 89 / 607

telnet
SecureStack C2 Configuration Guide 3-35
Syntax
set telnet { enable | disable } [ inbound | outbound | all ]
Parameters
Defaults
If not specified, both inbound and outbound Telnet service will be enabled or disabled.
Mode
Switch command, read ‐ write.
Example
This example shows how to disable inbound and outbound Telnet services:
C2(su)->set telnet disable all
Disconnect all telnet sessions and disable now (y/n)? [n]: y
All telnet sessions have been terminated, telnet is now disabled.
telnet
Use this command to start a Telnet connection to a remote host. The SecureStack C2 switch allows
a total of four inbound and / or outbound Telnet session to run simultaneously.
Syntax
telnet host [ port ]
Parameters
Defaults
If not specified, the default port number 23 will be used.
Mode
Switch command, read ‐ write.
Example
This example shows how to start a Telnet session to a host at 10.21.42.13:
C2(su)->telnet 10.21.42.13
enable | disable Enables or disables Telnet services.
inbound |
outbound | all
(Optional) Specifies inbound service (the ability to Telnet to this switch),
outbound service (the ability to Telnet to other devices), or all (both
inbound and outbound).
host Specifies the name or IP address of the remote host.
port (Optional) Specifies the server port number.