Enterasys SecureStack C2, Configuration Manual, Page: 600 / 607

access-list (standard)
18-76 Security Configuration
Parameters
Defaults
If number is not specified, the entire table of access lists will be displayed.
Mode
Any router mode.
Example
This example shows how to display IP access list number 101. This is an extended access list,
which permits or denies ICMP, UDP and IP frames based on restrictions configured with the one
of the access ‐ list commands. For details on configuring standard access lists, refer to “ access ‐ list
(standard) ” on page 18 ‐ 71. For details on configuring extended access lists, refer to “ access ‐ list
(extended) ” on page 18 ‐ 73
.
C2(su)->router# show access-lists 101
Extended IP access list 101
1: permit icmp host 18.2.32.130 any
2: permit udp host 198.92.32.130 host 171.68.225.126
3: deny ip 150.136.0.0 0.0.255.255 224.0.0.0 15.255.255.255
4: deny ip 11.6.0.0 0.1.255.255 224.0.0.0 15.255.255.255
5: deny ip 172.24.24.0 0.0.1.255 224.0.0.0 15.255.255.255
access-list (standard)
Use this command to define a standard IP access list by number when operating in router mode.
The no form of this command removes the defined access list or entry.
Syntax
To create an ACL entry:
access-list access-list-number { deny | permit } source [ source-wildcard ]
no access-list access-list-number [ entry ]
To insert or replace an ACL entry:
access-list access-list-number insert | replace entry
To move entries within an ACL:
access-list access-list-number move destination source1 [ source2 ]
Parameters
access ‐ list ‐
number
(Optional) Displays access list information for a specific access list number.
Valid values are between 1 and 199 .
access ‐ list ‐
number
Specifies a standard access list number. Valid values are from 1 to 99.
deny | permit Denies or permits access if specified conditions are met.