Enterasys SecureStack C2, Configuration Manual, Page: 591 / 607

show pwa session
SecureStack C2 Configuration Guide 18-67
Parameters
Defaults
If port ‐ string is not specified, PWA will enabled on all ports.
Mode
Switch command, read ‐ write.
Example
This example shows how to enable PWA on ports 1 ‐ 22:
C2(su)->set pwa portcontrol enable ge.1.1-22
show pwa session
Use this command to display information about current PWA sessions.
Syntax
show pwa session [ port-string ]
Parameters
Defaults
If port ‐ string is not specified, session information for all ports will be displayed.
Mode
Switch command, read ‐ only.
Example
This example shows how to display PWA session information:
C2(su)->show pwa session
Port MAC IP User Duration Status
-------- ----------------- --------------- ------------- ------------ ---------
ge.2.19 00-c0-4f-20-05-4b 172.50.15.121 pwachap10 0,14:46:55 active
ge.2.19 00-c0-4f-24-51-70 172.50.15.120 pwachap1 0,15:43:30 active
ge.2.19 00-00-f8-78-9c-a7 172.50.15.61 pwachap11 0,14:47:58 active
e nable | disable Enables or disables PWA on specified ports.
port ‐ string (Optional) Sets the control mode on specific port(s). For a detailed
description of possible port ‐ string values, refer to “ Port String Syntax Used
in the CLI ” on page 5 ‐ 2.
port ‐ string (Optional) Displays PWA session information for specific port(s). For a
detailed description of possible port ‐ string values, refer to “ Port String
Syntax Used in the CLI ” on page 5 ‐ 2.