Enterasys SecureStack C2, Configuration Manual, Page: 583 / 607

set pwa
SecureStack C2 Configuration Guide 18-59
set pwa
Use this command to enable or disable port web authentication.
Syntax
set pwa { enable | disable }
Parameters
PWA IP Address IP address of the end station from which PWA will prevent network access until the
user is authenticated. Set using the
set pwa ipaddress command as described in
“ set pwa ipaddress ” on page 18-62.
PWA Protocol Whether PWA protocol is CHAP or PAP. Default setting of PAP can be changed
using the
set pwa protocol command as described in “ set pwa protocol ” on
page 18-62.
PWA Enhanced
Mode Whether PWA enhanced mode is enabled or disabled. Default state of disabled can
be changed using the
set pwa enhancedmode command as described in “ set pwa
enhancedmode ” on page 18-68.
PWA Logo Whether the Enterasys Networks logo will be displayed or hidden at user login.
Default state of enabled (displayed) can be changed using the
set pwa displaylogo
command as described in “ set pwa displaylogo ” on page 18-61.
PWA Guest
Networking Status Whether PWA guest user status is disabled or enabled with RADIUS or no
authentication. Default state of disabled can be changed using the
set pwa
gueststatus command as described in “ set pwa gueststatus ” on page 18-64.
PWA Guest Name Guest user name for PWA enhanced mode networking. Default value of “guest” can
be changed using the
set pwa guestname command as described in “ set pwa
guestname ” on page 18-63.
PWA Guest
Password Guest user’s password. Default value of an empty string can be changed using the
set pwa guestpassword command as described in “ set pwa guestpassword ” on
page 18-64.
PWA Redirect Time Time in seconds after login success before the user is redirected to the PWA home
page.
Port PWA port designation.
Mode Whether PWA is enabled or disabled on his port.
Auth Status Whether or not the port state is disconnected, authenticating, authenticated, or held
(authentication has failed).
Quiet Period Amount of time a port will be in the held state after a user unsuccessfully attempts to
log on to the network. Default value of 60 can be changed using the
set pwa
quietperiod command as described in “ set pwa quietperiod ” on page 18-65.
MaxReq Maximum number of log on attempts allowed before transitioning the port to a held
state. Default value of 2 can be changed using the
set pwa maxrequests command
as described in “ set pwa maxrequest ” on page 18-66.
Table 18-8 show pwa Output Details (Continued)
Output What It Displays...
enable | disable Enables or disables port web authentication.