Enterasys SecureStack C2, Configuration Manual

Page: 533 / 607

clear radius accounting
SecureStack C2 Configuration Guide 18-9
Examples
This example shows how to enable the RADIUS accounting client for authenticating with the
accounting server at IP address 10.2.4.12, UDP authentication port 1800. As previously noted, the
“server secret” password entered here must match that already configured as the Read ‐ Write (rw)
password on the RADIUS accounting server:
C2(su)->set radius accounting server 10.2.4.12 1800
Enter secret:
Re-enter secret:
This example shows how to set the RADIUS accounting timeout to 30 seconds:
C2(su)->set radius accounting timeout 30
This example shows how to set RADIUS accounting retries to 10:
C2(su)->set radius accounting retries 10
clear radius accounting
Use this command to clear RADIUS accounting configuration settings.
Syntax
clear radius accounting { server ip-address | retries | timeout | counter }
Parameters
Mode
Switch command, read ‐ write.
Defaults
None.
Example
This example shows how to reset the RADIUS accounting timeout to 5 seconds.
C2(su)->clear radius accounting timeout
Configuring 802.1X Authentication
Purpose
To review and configure 802.1X authentication for one or more ports using EAPOL (Extensible
Authentication Protocol). 802.1X controls network access by enforcing user authorization on
selected ports, which results in allowing or denying network access according to RADIUS server
configuration.
server ip ‐ address Clears the configuration on one or more accounting servers.
retries Resets the retries to the default value of 3.
timeout Resets the timeout to 5 seconds.
counter Clears counters.