Enterasys SecureStack C2, Configuration Manual, Page: 208 / 607

show snmp context
6-20 SNMP Configuration
show snmp context
Use this command to display the context list configuration for SNMP’s view ‐ based access control.
Syntax
show snmp context
Parameters
None.
Defaults
None.
Mode
Switch command, read ‐ only.
Usage
An SNMP context is a collection of management information that can be accessed by an SNMP
agent or entity. The default context allows all SNMP agents to access all management information
(MIBs). When created using the set snmp access command (“ set snmp access ” on page 6 ‐ 17), other
contexts can be applied to limit access to a subset of management information.
Example
This example shows how to display a list of all SNMP contexts known to the device:
C2(su)->show snmp context
--- Configured contexts:
default context (all mibs)
set snmp view
Use this command to set a MIB configuration for SNMPv3 view ‐ based access (VACM).
Syntax
set snmp view viewname viewname subtree subtree [ mask mask ] [ included | excluded ]
[ volatile | nonvolatile ]
Table 6-7 show snmp view Output Details
Output What It Displays...
View Name Name assigned to a MIB view.
Subtree OID Name identifying a MIB subtree.
Subtree mask Bitmask applied to a MIB subtree.
View Type Whether or not subtree use must be included or excluded for this view.
Storage type Whether storage is in nonVolatile or Volatile memory
Row status Status of this entry: active , notInService, or notReady .