Enterasys SecureStack C2, Configuration Manual, Page: 186 / 607

clear port protected
5-48 Port Configuration
Example
This example shows how to display information about all protected ports:
C2(ro)->show port protected
Group id Port
----------------------
1 ge.1.1
1 ge.1.2
1 ge.1.3
clear port protected
Use this command to remove a port or group from protected mode.
Syntax
clear port protected [ port-string ] | [ group-id ]
Parameters
Defaults
If no parameters are entered, all protected ports and groups are cleared.
Mode
Switch command, read ‐ write.
Example
This example shows how to clear protected ports
ge
.1.1 through
ge
.1.3:
C2(rw)->clear port protected ge.1.1-3
set port protected name
Use this command to assign a name to a protected port group id.
Syntax
set port protected name group-id name
Parameters
Defaults
None.
port ‐ string (Optional) Specifies the port or ports to remove from protected mode.
group ‐ id (Optional) Specifies the id of the group to remove from protected mode.
Id can range from 0 to 2.
group ‐ id Specifies the id of this group. Id can range from 0 to 2.
name Specifies a name for the group. The name can be up to 32 characters in
length.