Enterasys SecureStack C2, Configuration Manual, Page: 134 / 607

clear lldp
4-28 Discovery Protocol Configuration
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example configures the management address, MED capability, and MED location
identification TLVs to be sent in LLDPDUs by port
ge
.1.1.
C2(rw)->set lldp port tx-tlv mgmt-addr med-cap med-loc ge.1.1
clear lldp
Use this command to return LLDP parameters to their default values.
Syntax
clear lldp { all | tx-interval | hold-multiplier | trap-interval | med-fast-repeat }
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example returns the transmit interval to the default value of 30 seconds.
C2(rw)->clear lldp tx-interval
med ‐ poe LLDP ‐ MED Extended Power via MDI TLV. Values sent include the
Power Limit (total power the port is capable of sourcing over a
maximum length cable) and the power priority configured on the
port. Only valid for PoE ‐ enabled ports.
port ‐ string Specifies the port or range of ports to be affected.
all Returns all LLDP configuration parameters to their default values,
including port LLDP configuration parameters.
tx ‐ interval Returns the number of seconds between transmissions of LLDP
frames.to the default of 30 seconds.
hold ‐ multiplier Returns the multiplier to apply to the transmit interval to determine
the time ‐ to ‐ live value to the default value of 4.
trap ‐ interval Returns the minimum time between LLSP trap transmissions to the
default value of 5 seconds.
med ‐ fast ‐ repeat Returns the number of fast start LLDPDUs to be sent when an LLDP ‐
MED endpoint device is detected to the default of 3.