Process Overview: Routing Protocol Configuration
Configuring RIP
13-2
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
13.1.1 Configuring RIP
Purpose
To enable and configure the Routing Information Protocol (RIP).
RIP Configuration Task List and Commands
Table 13-1
lists the tasks and commands associated with RIP configuration. Commands are
described in the associated section as shown.
NOTE:
Enabling RIP with the
router rip
and
network
commands is required if you
want to run RIP on the device. All other tasks are optional.
Table 13-1
RIP Configuration Task List and Commands
To do this...
Use these commands...
Enable RIP configuration mode and
associate a network.
router rip (
Section 13.1.1.1
)
network (RIP) (
Section 13.1.1.2
)
Allow unicast updates by defining a
neighboring router.
neighbor (RIP) (
Section 13.1.1.3
)
Configure an administrative distance.
distance (
Section 13.1.1.4
)
Apply offsets to RIP routing metrics.
ip rip offset (
Section 13.1.1.5
)
Adjust timers.
timers (
Section 13.1.1.6
)
Specify a RIP version.
ip rip send version (
Section 13.1.1.7
)
ip rip receive version (
Section 13.1.1.8
)