Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
13-1
13
Routing Protocol Configuration
This chapter describes the Routing Protocol Configuration set of commands and how to use them.
13.1 PROCESS OVERVIEW: ROUTING PROTOCOL CONFIGURATION
Use the following steps as a guide to configuring routing protocols on the device:
1.
Configuring RIP (
Section 13.1.1
)
2.
Configuring OSPF (
Section 13.1.2
)
3.
Configuring DVMRP (
Section 13.1.3
)
4.
Configuring IRDP (
Section 13.1.4
)
5.
Configuring VRRP (
Section 13.1.5
)
ROUTER:
The commands covered in this chapter can be executed when the device is
in
router mode
only. For details on how to enable router configuration modes, refer to
Section 3.3.3
.
NOTE:
The command prompts used in examples throughout this guide show a system
where VLAN 1 has been configured for routing. The prompt changes depending on your
current configuration mode, and the interface types and numbers configured for routing
on your system.