Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
6-38
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how to show Spanning Tree status for all Gigabit Ethernet ports:
6.2.2.2
set spantree portadmin
Use this command to enable or disable the Spanning Tree algorithm on one or more ports.
set spantree portadmin port-string
{
enable
|
disable
}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable Spanning Tree on Fast Ethernet front panel port 12:
Matrix>
show spantree portadmin ge.*.*
Port ge.0.1 has portadmin set to enabled.
Port ge.0.2 has portadmin set to enabled.
Port ge.0.3 has portadmin set to enabled.
Port ge.0.4 has portadmin set to enabled.
Port ge.0.5 has portadmin set to enabled.
Port ge.0.6 has portadmin set to enabled.
NOTE:
Spanning Tree must be disabled on ports that will be dedicated as IP routing
uplinks (VLANs). To display administrative status for all Spanning Tree ports, use the
show spantree portadmin
command as detailed in
Section 6.2.2.1
. For details on
configuring VLANs for IP routing, refer to
Section 3.3.2
.
port-string
Specifies the port(s) for which to enable or disable
Spanning Tree. For a detailed description of possible
port-string
values, refer to
Section 4.1.2
.
enable
|
disable
Enables or disables Spanning Tree.
Matrix>
set spantree portadmin fe.0.12 disable