PREPARING YOUR RADIO FOR USE
Attaching / removing the antenna
1.
To attach, carefully align the antenna with the
socket. Screw in the antenna and clockwise
(taking care not to cross the thread) until it is
seated fi rmly.
(A)
2.
To remove, unscrew the antenna
anti-clockwise.
(B)
1.
To attach
(C)
, locate the pegs on the bottom of
the battery into the slots on the radio and pull
the 2 latches
downwards, carefully pushing
the battery into the radio. Release the latches
ensuring the battery is full attached.
2.
To remove
(D)
, pull down the 2 latches and
carefully pull the battery away from radio.
A
B
C
D
SWITCHING ON, RECEPTION
AND SWITCHING OFF
1.
To switch on rotate the on/off/volume control
(1) on the top of the radio clockwise, you will
hear a click from the control.
2.
When the radio has passed its diagnostic tests,
it will emit a fanfare tone.
3.
The radio will enter standby mode. This is
indicated by the LED fl ashing Amber once
every 5 seconds, indicating the radio is ready
for use.
4.
Adjust the volume control (1) to select the
desired volume level.
5.
Using the channel/contact list control (2)
ensure that you have the correct channel/
contact selected.
6.
When receiving a valid signal the LED will
illuminate steady green and audio will be
emitted from the radio’s speaker or audio
accessory (if attached)
7.
When fi nished using the radio, switch off by
turning the on/off/volume control (1) counter
clockwise until it clicks and the radio will be
switched off.
TRANSMITTING
1.
Perform steps 1 through to 5 of ‘Switching On,
Reception and Switching Off.’
2.
Before transmitting, monitor the channel and
make sure it is clear.
3.
When receiving a signal, wait until the signal
stops before transmitting. The radio cannot
transmit and receive simultaneously.
4.
Press the PTT (Push To Talk) button (4) to begin
your transmission. To confi rm transmission the
LED illuminates red.
5.
For best transmitted speech quality you must
talk directly into the radio's microphone (10) at
around 4cm between your mouth and the radio.
6.
Please note: with your mouth further away, you
will transmit poor quality speech.
7.
When the transmission is fi nished, release the
PTT button.
EU DECLARATION OF CONFORMITY
Hereby, Entel UK Limited
Declares that the radio equipment type
DX400 series is in compliance with
Directive 2014/53/EU
The full text of the EU declaration of
conformity is available at the following
internet address:
www.entel.co.uk/red
www.entel.co.uk
DX
Digital Series
Quick Start User Guide
Attaching / removing the battery pack
Designed in the United Kingdom
A
ll R
ig
ht
s R
es
er
ve
d. C
op
yr
ig
ht E
nt
el U
K L
td
.