Enraf Nonius TENSMED S82, Instructions For Use Manual

Page: 7 / 36

1727751-51
7
It is important to read the following instructions carefully before using your
Tensmed S82. The manufacturer cannot be held responsible for the results of using
this device for any purposes other than described in these operating instructions.
Should the use of this device lead to an undesirable event such as death or
serious injury to the user, the manufacturer and the competent authority of the
Member State MUST be informed without delay!
CONNECTIONS
Accessories
Cable connections
One or two cables may be used depending on whether you have chosen to use one or two
channels of the unit.
To connect the cable connector to the device, plug it into the appropriate inlet in the upper part
of the unit.
The inlets are situated exactly under the correspondent channel (left or right). Insert the cable at
the channel you want to use.
Electrode application
Take the electrodes from the original package; all new electrodes have a seal on the package.
Be sure that the device is off. To start, connect the two cable plugs to the electrodes, then
disconnect the electrodes from their position and apply them on the skin. To place the electrodes
correctly, see the pictures included in this manual.
After the use, place the electrodes in their original position again.
ATTENTION: do not unplug the electrodes if the unit is working.
LABELLING AND SYMBOLS
It refers to the manufacturer name and address
Warning
This symbol on your device indicates that it complies with the directives on medical
devices (93/42/CEE 47/2007CEE). The number of the notified unit is 0476.
It indicates that this is a II class device.