Page 7 of 24
EN109-1413761-43 IFU
4
SETUP
No specific installation activities are required that would require the assistance of a technician
authorized by Enraf-Nonius.
UNPACKING
The unit weighs approximately 80 kg.
We advise you to unpack the device with at least 2 persons
.
INSPECTION
Immediately upon unpacking the unit, check if the package contains all items listed above in the
package contents and check the device for any damage.
SETUP
Level the device by adjusting the rubber feet for optimal stability.
The connection for the mains cable is located at the rear, on the underside of the frame.
After the mains cable has been connected, switch on the device by using the switch located next to
the mains cable connection.
The Crosswalker is now ready for use.
In case of damage, contact your local distributor. Do NOT use the device!
To avoid the risk of electric shock, this equipment must only be connected to a mains supply
with protective earth.
No unauthorized modification of this equipment is allowed.
Check the technical data section to make sure the mains supply complies with the technical
specifications of the device.
Check the technical data section to make sure the environment complies with the
environmental conditions for use of the device.
Do not install the device next to a heat source or in “wet
-
rooms” or hydrotherapy rooms
Avoid exposure to direct sunlight.
