Enovation Controls Murphy PowerView PV485, Operation Manual

Page: 24 / 53

2021- 0306 - 2507 24 00-02-1207
Display Source Address
A llows the operator to set the address claim of the display when used on the CANbus.
This address is relative to the address from which the ECU requires the TSC1 to be
broadcast. Consult your engine manufacturer or dealer to obtain the
correct source address the display should
utilize to communicate correctly with
the engine ECU. Factory set to 3 and changed per Engine Manufacturer setting.
ECU Source Address
A llows the operator to set the source address to which the ECU will be
connected . Normally set to 0, 1 or 2 per SAE J1939 specifications.
Factory set to 0.
ECU Enable Delay
Allows the operator to set a delay time (in seconds) before
the ECU enable is active . To use this feature t he ECU enable power must be
controlled by the display output with an external relay . Applying a d elay to the ECU enable
power allows the operator the ability to adjust the time required for the
ECU to establish communication with the display/ controller
after powe r up.
TSC1 Setup
This selection will allow the operator to configure th e following settings for Torque
Speed Control (TSC) 1:
Menu Item Choices/Description
TSC1 Enable
Enabled: display will transmit TSC1 messages.
Disabled: display will not transmit TSC1 messages.
TSC1 Independence
Enabled:
allows the user to set a separate source
address for TSC1 throttling from the display’s claim
address. This should only be done if the service
technician knows this to be true.
Disabled:
TSC1 throttling from the
display’s claim
address
.
TSC1 Source Address ( numeric value )
Formatted: Centered
Formatted Table
Formatted: Font: Bold
Formatted: Font: Bold
Formatted Table
Formatted: Indent: Left: 0 cm
Formatted: Space After: 0 pt, Tab stops: 1.43 cm, Right +
Not at 14.84 cm
Formatted Table
Formatted: No bullets or numbering
Formatted: Font: Bold