Recon IS
ENMET
Manual Revision Date – June 15, 2017
P a g e
|
2
Manual Part No. – 80006-022
1.0 Introduction
The
RECON-IS
Series instruments are designed to detect toxic gases and oxygen concentrations in ambient air and has been
approved to be used in hazardous locations. Their one button operation, low power consumption and small size makes them ideal for
use in many situations like, oil field, chemical plant and the mining industry as well as confined space entry, general construction and
environmental industries.
N
OTE
:
All specifications stated in this manual may change without notice.
1.1 Unpack
Unpack the
Recon IS
and examine it for shipping damage. If such damage is observed, notify both
ENMET
customer service
personnel and the commercial carrier involved immediately.
Regarding Damaged Shipments
N
OTE
: It is your responsibility to follow these instructions. If they are not followed, the carrier will not honor any claims for
damage.
This shipment was carefully inspected, verified and properly packaged at
ENMET
and delivered to the carrier in good
condition.
When it was picked up by the carrier at
ENMET
, it legally became your company’s property.
If your shipment arrives damaged:
Keep the items, packing material, and carton “As Is.” Within 5 days of receipt, notify the carrier’s local office and
request immediate inspection of the carton and the contents.
After the inspection and after you have received written acknowledgment of the damage from the carrier, contact
ENMET
Customer Service for return authorization and further instructions. Please have your Purchase Order and Sales
Order numbers available.
ENMET
either repairs or replaces damaged equipment and invoices the carrier to the extent of the liability coverage, usually
$100.00. Repair or replacement charges above that value are your company’s responsibility.
The shipping company may offer optional insurance coverage.
ENMET
only insures shipments with the shipping company
when asked to do so in writing by our customer. If you need your shipments insured, please forward a written request to
ENMET
Customer Service.
Regarding Shortages
If there are any shortages or questions regarding this shipment, please notify
ENMET
Customer Service within 5 days of receipt at
the following address:
ENMET
680 Fairfield Court
Ann Arbor, MI 48108
734-761-1270 Fax 734-761-3220
Toll Free: 800-521-2978
1.2 Check Order
Check, the contents of the shipment against the purchase order. Verify that the
Recon IS
is received as ordered. If there are
accessories on the order, ascertain that they are present. Check the contents of calibration kits. Notify
ENMET
customer service
personnel of any discrepancy immediately
1.3 Safety Settings
Please read the following information carefully before using the detector.
Do not use a damaged gas detector.
Do not open the RECON-IS in a possible explosive working environment.
Caution should be used if the background oxygen concentration is greater than 20.9% by volume since there is a greater
risk of ignition of a combustible gas if present. Oxygen concentration in the air exceeding 20.9%vol could reduce the anti-
explosion feature of the detector. ENMET Cooperation recommends that a "Bump Test" be performed to confirm sensor
responds and to ensure that the audio, visual and vibration alarms are working properly.