Engl RACKHEAD 1060, Manual

Page: 9 / 25

For Both Channels Shared Switches
Mute Preamp A+B
(switch)
Mutes both channels; Tuner Out remains on
Effect A (switch)
Each switch activates and assigns the FX loop directly to the given channel. They
are mutually exclusive: enabling one disables the other.
The Balance knob on the rear panel adjusts the mix of wet (effects) and dry signals.
Effect B (switch)
Swap Preamp
(switch)
Flips the two inputs, assigning jack A to channel B and jack B to channel A
Bridged Poweramp
(switch)
Bridges the stereo power amp (default setting); LED lights up to indicate bridged
mode
The power amp is now a mono block delivers 1000W at 8 ohms for both channels!
Master (knob) Adjusts the volume of the power amp
Protect/Limiter
(red LED)
Protect/Limiter -LED lights for about 2 seconds after switching on the amplifier and
goes out afterwards.
It may flash now and and then.
Constant lightning shows that the limiter of the power amplifier is working to limit
the output power.
This
has to be avoided otherwise the power amplifier can be damaged.
Page 9 / 25