Quick Installation Guide
EZ Hotspot Extender
EnGenius Europe | Veldzigt 28, 3454 PW Utrecht (NL)
0900-WIFIABC | www.wifiabc.com
Disclaimer: Information may be subject to changes without prior notification.
Follow us
https://www.linkedin.com/company/engeniuseurope
https://plus.google.com/+EngeniusEuropeBVDeMeern
https://www.youtube.com/user/engeniuseuropebv
https://twitter.com/engeniuseu
EZ Hotspot Extender
Remove the rear bottom panel.
Type ezhotspot.eu in your browser.
Please select a Hotspot with 40% or more signal quality where
possible to ensure a good and stable connection. Select the SSID of
the hotspot and click on ‘Join Network’.
Connect one end of the Ethernet cable (not supplied) to the LAN
(PoE) port on the EZ Hotspot Extender. The LAN (PoE) port can be
founded on the right-hand side as seen from the back of the device.
Connect the other end of the Ethernet cable to the PoE injector’s
PoE port. Connect the Power Adapter DC inlet to the 24V DC IN of
the PoE Injector and the power adapter to an electrical outlet. The
device is ready for configuring when the two LEDs (Power and
Wireless) are lit and the green LED stops blinking. This may take
about 30 seconds.
Both user name and password are
root
.
Scan for Hotspots.
Check the details and choose ‘Submit’. Do the same on the next
page, change the encryption if you prefer and choose ‘Save &
Apply’.
Go to your network center, view the SSIDs (network names) and
select EnGenius-ezhotspot.euXXXXXX. You can find this address at
the back of your product.
When connecting to Wifispots of UPC and Ziggo, the encryption must
be adjusted. The steps you need to perform themselves are indicated,
you only need to click.
Note!
Auto recovery: When extender cannot connect due to insufficient
range or incorrectly credentials such as encryption key (if any), a SSID
broadcasting “EnGenius-CannotJoinOrNotSetup” will appear. Kindly
retry again.
1
2
3
4
5
6
7
8
9
