ENFORCER 4-Channel CCTV “Brick” Power Supply
4
SECO-LARM U.S.A., Inc.
Troubleshooting:
CCTV
Power Supplies
Plug-in
AC Adapters
Plug-and-Play
Backup Batteries
(SB-P1012-26Q shown)
Voltage
Converters
PS-U1812-PULQ
ST-UV12-S1.0Q
SB-L10V1-20Q /
SB-P1012-26Q
ST-LA130-TTQ
NOTICE:
The information and specifications printed in this manual are current at the time of publication. However, the
SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM reserves the right to
change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors. Trademarks
are the property of SECO-LARM U.S.A., Inc. or their respective owners.
Copyright © 2014 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or
in part, without the written permission of SECO-LARM.
LIMITED WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while
used in normal service for two (2) years from the date of sale to the original customer. SECO-LARM’s obligation is limited to
the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty
is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or
alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such
equipment is not operating properly as a result of causes other than defects in material and workmanship. The sole
obligation of SECO
-
LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at
SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential
personal or property damage of any kind to the purchaser or anyone else.
SECO-LARM
®
U.S.A., Inc
.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
PICSN7
Phone: (949) 261-2999 | (800) 662-0800 Email: [email protected]
MiPA-U0405-NULQ_141013.docx
Also Available from SECO-LARM:
Camera will not turn on
•
Make sure that all wires are connected securely and that
the polarity is correct
No output power from power supply
•
Check to see that the main power cable is securely
connected to the power supply
•
Check the total supply current for all connected device
does not exceed 5A
PA-U0405-NULQ
4-Channel CCTV “Brick” Power Supply
Manual
