Installation
900-0258-01-00 Rev A
19
8. Lightly brush the terminal contact surface areas with a brass bristle brush or the
equivalent, then coat with dielectric grease such as NO-OX-ID or NCP-2. Carefully
install short bus bars using M10 bolts so that batteries are connected in series. Torque
bolts to 28.1 to 33.8
N
⋅
m
(287 to 344 kgf
⋅
cm) or 531 Lbf
⋅
in, then place protection covers
over each bus bar.
Figure 12 Install Short Bus Bars and Insulating Covers
Insulating Plastic
Protection Cover
Short Bus Bars
Summary of Contents for Outback Power EnergyCell 1000XLC
