Installation
900-0258-01-00 Rev A
13
Installation Procedure
1. Install 4 support bars on module frame and fasten with M5 screws (3 screws per bar).
The set of 2 bars closest to the positive battery terminals should be installed adjacent to
each other, while the bars closest to the negative terminals should be installed with their
outer ends flush with the outer edge of the module frame and a gap in the module center
between the two bars.
Figure 6
Install Support Bars
Support Bars
M5 Screws
M5 Screws
Summary of Contents for Outback Power EnergyCell 1000XLC
