• 6 •
10. CONTROL PANEL
LED Indicators
(All Models)
•
CHECK (red) LED lit:
Indicates that the battery is not properly connected to the charger.
•
CHECK (red) LED flashing:
Indicates that the charger is in abort mode.
•
CHARGING (yellow) LED lit:
Indicates that the charger has detected a battery and
is charging it.
•
CHARGED (green) LED lit:
Indicates that the battery is fully charged and the
charger is in maintain mode.
NOTE:
See the Operating Instructions section for a complete description of the
charger modes.
Display Button
(Models OMAX-12A-1B, OMAX-25A-1B)
Press this button to set the digital display to show one of the following.
•
Battery % –
The display shows an estimate of the percent of charge of the battery
connected to the charger battery clamps.
•
Voltage –
The display shows the voltage at the battery clamps in DC volts.
Display Button
(Models OMAX-50A-1B, OMAX-40AS-3B, OMAX-50AS-3B)
Press this button to set the digital display to show one of the following.
•
Percent:
The display shows an estimate of the percent of charge of the battery
connected to the charger battery clamps.
•
Volts:
The display shows the voltage at the battery clamps in DC volts.
•
Amps:
The display shows charge current provided by the charger in DC amps.
Charge Button
(Models OMAX-6A-1B, OMAX-12A-1B, OMAX-25A-1B)
Press this button to set the charger to one of the following settings.
•
On:
Indicates the charger is in charge mode.
•
Off:
Indicates the charger is in test mode.
Output Button
(Model OMAX-50A-1B)
Press this button to set the charger to one of the following settings.
•
On:
Indicates the charger is in charge mode.
•
Off:
Indicates the charger is in test mode.
Bank Button
(Models OMAX-40AS-3B, OMAX-50AS-3B)
Press this button to set the charger to one of the following settings for each bank.
•
Charge:
Indicates that bank is in charge mode.
•
Test:
Indicates that bank is in test mode.
11. OPERATING INSTRUCTIONS
This battery charger must be properly assembled in accordance with the
assembly instructions before it is used.
Charging
1.
Make sure that you have an Odyssey
®
battery.
2.
Ensure that all of the charger components are in place and in good working
condition, for example, the plastic boots on the battery clips.
3.
Connect the battery following the precautions listed in sections 6 and 7.
4.
Connect the AC power following the precautions listed in section 8. Make sure to
place the charger on a dry, non-flammable surface like metal or concrete.
5.
Select the appropriate settings for your battery.
6.
To disconnect, reverse the procedure.
NOTE:
Do not connect one OMAX-40AS-3B or OMAX-50AS-3B sequencing charger
to two or more batteries connected in a series. If the positive terminal of one battery is
connected to the negative terminal of another battery, then they are connected in a series
and must not be connected to the same OMAX-40AS-3B or OMAX-50AS-3B charger.
Summary of Contents for Odyssey Ultimizer OMAX-12A-1B
Page 14: ...14...
