5
MECHANICAL INSTALLATION
The charger can be wall or floor mounted.
If wall mounted make sure that the surface is free of
vibrations and the charger is mounted in a vertical position.
If floor mounted make sure that the surfaces are free of
vibration, water, humidity.
You must avoid areas where the chargers may be splashed
with water.
The charger must be held by 2 or 4 fixings suitable for the type
of support. The drilling pattern varies according to the model
of charger (please refer to the technical data sheet).
ELECTRICAL CONNECTION
To the mains supply
You may only connect to 1-phase 230Vac (+/- 10%)
or 3-phase 400Vac (+/- 10%) 50/60Hz mains supply
(depending on the type of the charger) by means
of a standard socket and an appropriate circuit
breaker (not supplied ). The current consumption is shown on
the charger’s information plate.
To the battery
The charger must be connected to the battery by the cables
supplied:
• The RED cable to the battery’s POSITIVE terminal.
• The BLACK cable to the battery’s NEGATIVE terminal.
Polarity must be observed. Any reversal of polarity will blow
the output fuse, prevent charging and cause DF2 fault code to
be displayed.
Please refer to the Messages and fault codes.
TFT SCREEN
Off-charge display
With the charger in waiting mode, the display shows
information concerning the charger (top and bottom lines):
1. Charger type
2. Software version.
3. Waiting indication.
4. Date and time of the charge.
Ref
Function
1
Charge info
2
Charge voltage (total V and V/c)
3
Charge time
4
Battery temp.
5
Battery ID
6
Wi-IQ warnings
7
USB connection
8
Charge Ah
9
Charger type and charging profile
10
% of charge
11
Charge current
12
Equal mode
13
Date/time
14
Wi-IQ link
Initiating charging
1. Connect the battery. If default setting (Autostart ON) then
the charge will start automatically or otherwise press the
Start/Stop button.
The charger will start the countdown process
and will start displaying the following information
Charge screens
1
3
2
4
5
6
7
8
9
11
10
12
13
14
Without Wi-IQ
®
With Wi-IQ
2
3
4
11
8
1
5
10
7
2
3
4
11
8
1
5
10
7
6
9
Ref
Function
1
Non blocking faults
2
Voltage
3
Current
4
Charging profile
5
Charging time
6
Warnings from Wi-IQ
7
Battery T°C
8
Ah charged
9
Wi-IQ linked
10
Date/time
11
State of charge and progress
