COMPONENT MAINTENANCE MANUAL
BA27
24-01-01
T
h
is docum
ent
contains D
a
ta
control
led by th
e U.S. Export Admini
str
a
tion
Reg
u
lati
ons. Di
versio
n or use
contrary to U.S. law is
proh
ibit
ed
(6)
Connect the negative wire to the negative terminal of the front
monobloc using binx nut (140) and plain washer (130), tighten the nut
to a torque of l.0 ± 0.1 Nm and then place nut cover (150) over the
terminal.
(7)
Locate and fix tie wrap block (110) in position as shown in IPL Figure
1.
(8)
Secure black wire to tie wrap blocks using wire ties (100).
(9)
Take the series lamination (120) connect the two monoblocs together
using two binx nuts (140) and two plain washers (130), tighten the
nuts to a torque of l.0 ± 0.1 Nm and then place nut covers (150) over
the terminals.
B.
Fit
Lid
(1)
Locate outer case cover assembly (180) to battery, ensuring cut out in
cover fits over the handle.
(2)
Ensure holes in case cover (180) aligns with holes in battery case
through which pop rivets enter.
(3)
Using 10 rivet fastenings (210), secure case cover to battery case
using a pop-rivet gun. Ensure each rivet is located flush to the case
cover. On the monobloc vent lid side, ensure the rivet is firmly home
prior to completing operation.
Page 29
Mar 11/16