background image

2

017-950-B1-001, Rev. A (07/2020)

1.1  Communications Module

The Communications Module consists of the Element Monitoring Module (EMM), Cable Modem Module (CMM) and Smart 

AlphaGuard™ (SAG) battery balancer.  The embedded Cable Modem Module (CMM) may be ordered factory-installed or 

added later to the Inverter Module by qualified personnel or Alpha

®

 Service Depot.  The CMM embedded DOCSIS

®

 Status 

Monitoring unit enables monitoring of Alpha power supplies through existing cable network infrastructure.  Advanced 

networking services provide quick reporting and access to critical powering information.

The CMM utilizes Simple Network Management Protocol (SNMP), standard SCTE-HMS and Alpha Management 

Information Bases (MIBs) to provide network status monitoring and diagnostics.  A web interface enables authorized 

personnel direct access to advanced diagnostics using a common web browser.  This guide pertains to all models and 

standard options. Refer to the technical manual for additional details on advanced status monitoring using the SFP optical 

port.

The EMM supports the Smart Display functionality and provides the communication interface between the inverter module 

and the Cable Modem module.  It also supports the necessary data storage and performs optional advanced AlphaAPPs 

functions such as logging power supply events, utility events, and battery health analysis.  Additionally, the EMM provides 

the interface for the local Ethernet interface and logic for the ancillary equipment such as tamper switches.

1

3

2

4

6

1

COM  Indicator LED

2

Cable Modem Power (PWR) Indicator

3

Downstream LED

4

Upstream LED

5

Small Form-factor Pluggable (SFP) Port

10

11

12

13
14

15

Fig. 1-2, Communications Module Features

6

Online LED

7

Ethernet Status LED

8

Alarm / Ready LED

9

Rx/Tx Power LED

10

Environmental (ENV) Control Connector

11

Smart AlphaGuard (SAG) Connector 

12

Ethernet (ETH) Connector

13

Tamper (TPR) Switch Connector

14

Reset Button

15

RF Connector for CMM

Cable Modem Module (CMM)

Element Monitoring 

Module (EMM)

Smart AlphaGuard (SAG)

5

7
8
9

Summary of Contents for Alpha Broadband UPS








Reviews: