12
Doc
L4540
_a
8. Screens
Local mode allows to operate a single EVOP hydraulic
power unit via the small screen and hand control
pendant provided on each unit. This mode is used for
setting up individual pumps prior to the lift, or for simple
operations of individual pumps that do not require
synchronized movement.
Before using this mode, ensure the Local/Remote
switch on the front panel is set to “Local”.
8.1 Initial Screen
Figure 7: Local Mode Initial Screen Details
This is the first screen shown by the system in local
mode. From this screen the operator can access to the
rest of screens in the system and set the features for the
movements.
When the Start icon on the screen is pushed, the system
will inquire the ID and Password to log into the user
profile.
The system is submitted with the default user profile
which is recorded with the user name: enerpac and
password: 100.
8.2 Main Screen
Figure 8: Main Screen Details
This is the main menu screen of the software in local
mode.
From this screen, the user can access the screens to set
up EVOP’s parameters. These screens are the screens
to arrange cylinder’s movements and the screens where
the operator can adjust other parameters of the software
not related with the movements.
8.2.1 Setup Pop Up
Figure 9: Setup Pop Up Details
In this pop up the user can access Work Parameters,
Spans, Offset, Calibration, Tare, pressure Sensor
Calibration and Network screens.
Tapping on each button the user can access the screens
of Set Up section.
The background color of this section is blue. Every
screen of this section will have a blue background.
8.2.2 Movements Pop Up
Figure 10: Movements Pop Up Details
In this pop up the user can access Manual, Preload,
Automatic, Fast Retract and Depressurize screens.
Tapping on each button the user can access the screens
of movements section.
The background color of this section is gray. Every
screen of this section will have a gray background.