12
Figure 6, Cutter Open
Figure 7, Cutter Closed
7.7 Cutting Procedure (typical)
1. Be certain that the properties of the material to be cut
do not exceed the stated maximum limits applicable
to your cutter model. Refer to the chart in Section 2.1
of this manual.
2. Place the material to be cut between the blades.
Be sure that it is perpendicular to the blade axis, as
shown in Figure 4. Refer to instructions in Section 7.5
for additional information.
NOTICE
Failure to properly position the material in
the shear blades may result in blade breakage and
reduced cutting efficiency.
3. Start the pump motor.
4. Turn the control knob to the right and hold it until the
item has been fully cut.
5. Turn the control knob to the left and hold it until the
blades are opened to the desired position.
6 Release the control knob. The control knob will
move to the neutral position and the blades will stop
opening.
8.0 MAINTENANCE
8.1 Periodic Maintenance Table
Refer to the Periodic Maintenance Chart (Table 1) for a
list of various routine checks and procedures.
NOTICE:
WARNING
Disconnect pump from AC power
supply before performing any cleaning, maintenance
or repair procedures. Failure to observe this
precaution could result in death or serious personal
injury.
8.2 Cleaning
Clean the cutter using a dry cloth or compressed air.
For plastic surfaces, use a cloth slightly dampened with
water.
NOTICE:
CAUTION
To prevent possible injury, always wear
safety glasses or face mask when using compressed
air.
• Be sure there are no traces of oil, grease or corrosive
substances on the tool, especially on the grips.
• Use a damp cloth and soapy water to clean plastic
components.
• Do not use gasoline or thinner to clean the tool.
Summary of Contents for EDCH130
Page 15: ...Notes...
Page 16: ...WWW ENERPAC COM...
