Energie Aquapura 12, Installation And Instruction Manual, Page: 35 / 56

ENERGIE Page | 33
18. Error code
Protect/fault
Fault
display
Reason Elimination methods
Standby Non
Normal boot Non
Inlet Temp Sensor Fault P01
The temp. Sensor is broken
or short circuit
Check or change the
Outlet Temp Sensor Fault P02
The temp. Sensor is broken
or short circuit
Check or change the
Hotwater Temp Sensor
Fault
P032
The temp. Sensor is broken
or short circuit
Check or change the
AT Sensor Fault P04
The temp. Sensor is broken
or short circuit
Check or change the
Coil temp Sensor Fault P153
The temp. Sensor is broken
or short circuit
Check or change the
Suction temp Sensor Fault P17
The temp. Sensor is broken
or short circuit
Check or change the
Exhaust temp Sensor Fault P181
The temp. Sensor is broken
or short circuit
Check or change the
Exhaust Overtemp Fault P182 The compressor is overload
Check whether the system of the
compressor running normally
Exhaust Pressure Sensor
Fault
PP1
The pressure Sensor is
broken
or short circuit
Check or change the pressure
Sensor or pressure
Suction Pressure Sensor
Fault
PP2
The pressure Sensor is
broken
or short circuit
Check or change the pressure
Sensor or pressure
EVI Inlet Temp Sensor
Fault
P001
The temp. Sensor is broken
or short circuit
Check or change the
EVI Outlet Temp Sensor
Fault
P002
The temp. Sensor is broken
or short circuit
Check or change the
Low AT Protection TP The ambient temp. is low
Flow Switch Protection E032
No water/little water in water
system Check the pipe water flow and
water pump
Electric Overheat Protection E04
The electric-heater protection
switch is broken
Check to see whether the
electric heater has been
running under the
temperature
over 150
℃
for a long time
Compressor Overcurrent
Shutdown Fault
E051 The compressor is overload
Check whether the system of
the compressor
running normally
Communication Fault E08
Communicat ion failure
between wire controller and
mainboard Check the wire connection
between remote wire controller
and main board
Communication Fault(Fan ) E081
Speed control module and
main board communication
fail
Check the communication
connection