www.energetics.eu
6
Motion control
Walking belt speed can be increased, decreased or stopped using the Motion Control sensors on the handlebars.
To do this follows the instructions below:
1. Press the
MOTION CONTROL button on the console to switch the
motion control functions on and off:
• When the LED light is ON the MOTION CONTROL is active.
• When the LED light is OFF the MOTION CONTROL is off.
2. After switching on the MOTION CONTROL wave your right hand approxi-
mately 10 cm above the motion sensor on the right handle bar to increase
the speed. The sensor will sound one short BEEP per scan and speed up by
0.1 km/h per BEEP. Holding your right hand approximately 15 cm above the
right sensor constantly results in the sensor sounding one long BEEP per
second and speeding up by 1.0 km/h per second.
3. Wave you left hand approximately 15 cm above the motion sensor on the
left handle bar to decrease the speed. The sensor will sound one short
BEEP per scan and decrease speed by 0.1 km/h. Holding your left hand
approximately 10 cm above the left sensor constantly results in the sensor
sounding one long BEEP per second and decreasing speed by 1.0 km/h per
second.
(2) Use right sensor to speed up.
(3) Use left sensor to slow down.
COOL DOWN
After completion of each program the TIME LED window will show „COOL“ and blink then start a 50 second cool down
procedure. Time counts down from 01:00 to 00:00 and speed stays at 3.2 km/h and the incline level stays at level 0.
After the time counts down to 00:00 the belt stops and returns to PAUSE/STOP status. Press the STOP/PAUSE button to
return to POWER ON status. To escape the cool down procedure press the STOP/PAUSE button once any time during
the process to enter the PAUSE/STOP status and press the STOP/PAUSE button again to enter the power on status.
Summary of Contents for PR 990 HRC
Page 2: ...www energetics eu...
Page 59: ...59...
