1 of 2
ENER029 Double Wall Sockets with 2x USB
Fitting and Wiring Instructions
1.
Before commencing work, isolate the mains power supply and remove the fuse in the
fuse box or switch off the circuit breaker in the consumer unit.
2.
If unit is to be used as a replacement for an existing product, remove existing unit from
its location and disconnect the wiring.
3.
Connect the wires as shown in appropriate wiring diagram below. Use green/yellow
sleeving on earth conductors not insulated. Ensure terminals are properly tightened and
no bare wire is visible. Push back unit into mounting box making sure conductors are
not trapped.
4.
Screw the unit to the mounting box using screws provided. Do not over-tighten fixing
screws. If supplied, fit the screw cover caps by carefully inserting & pressing inwards
into the fixing screw holes.
5.
These products must be installed in accordance with the latest Building and IEE wiring
regulations. If in any doubt, please contact a qualified electrician.
USB Charger Information:
2 Gang 13A Switched Socket with 2 x USB ports for charging mobile devices such as
mobile phone, MP3 player, and tablets. 2.1A 5V output from the USB ports
The total charger output current is 2.1A. This can be delivered from just one USB port or
divided between the two as required. 2.1A is sufficient output to charge the majority of
