55
8.3
RSTP
RSTP is the abbreviation of Rapid Spanning Tree Protocol, which provides the same function
as STP, and is completely backward compatible with 802.1D STP. Relative to the STP, the
most important feature is "fast", if a LAN within the bridge are supported RSTP protocol,
and the administrator configured properly, once the network topology changes, and to
regenerate the topology tree only need not more than 1 second time (traditional STP takes
about 50 seconds).
Go to Network Management-- RSTP bar, in the RSTP spanning tree page, you can enable /
disable the RSTP spanning tree function, set the RSTP parameters, etc., and click the
<Modify> button to modify the settings. After setting, click the bottom of the page. Save the
Save button to save the configuration.
The interface item is described as follows:
Interface
Item
Description
RSTP Setup
Select to enable / disable the RSTP function.
Note: The following parameter settings can only be set if the RSTP function is
Summary of Contents for 221890
Page 5: ...5 1 3Board Diagram...
