Enecsys Single Repeater, User Manual

Page: 15 / 25

Single Repeater Installation Manual Intelligent Reliable Power
11
© ENECSYS 2010. All rights reserved.
2.4 Wall mounting the Enecsys Repeater (screw fixed method)
When mounting an Enecsys Repeater always ensure that you have connected the power supply
and antenna to the device before the final fit.
The screw fixing points are shown in Figure 5 on page 9 .
1. Attach the antenna to the RP SMA plug on the right hand side of the Enecsys Repeater, screw
the antenna into place in a clockwise direction.
2. Connect the supplied external 5V DC plug top power supply to a mains supply AC power
source.
3. Connect the 5V DC power supply jack-plug to the DC power port on the reverse of the Enecsys
Repeater, thread the cable through the semi-circular channel on the back-plate of the Enecsys
Repeater, this will help to keep the cable in place and prevent it from becoming detached.
4. Select the appropriate location for mounting the Enecsys Repeater.
5. Using the wall mount template locate the desired position of the Enecsys Repeater; ensure
that there is adequate free-space around the Enecsys Repeater to allow for any future move-
ment or maintenance of the device.
6. Mark two horizontal spots on the wall 50 millimetres apart, install the screws into the wall.
7. Line up the back plate holes of the Enecsys Repeater with the screws on the wall and then
slide the Enecsys Repeater down to fix the unit in position.