1
Ultimate Trilennium
®
Astragal
Cut Down Instructions
8817 West Market Street
Colfax, NC 27235 | 800.334.2006
www.enduraproducts.com
Rev. Date: 11.06.2017
©2017 Endura Products, Inc.
U.S. Patents: 9,404,294 and other patents pending
• All cuts should be from the
top of the astragal.
• If the trim strip is present, remove from the astragal body.
• The
maximum cut down length
for the Ultimate Trilennium Astragal is dependent upon the handle height of the lock:
• For
6/8 Astragals
, the minimum length of the astragal is the handle 38".
• For
7/0 Astragals
, the minimum length of the astragal is the handle 38" OR a total length of 74" - whichever
is greater.
• For
8/0 Astragals
, the minimum length of the astragal is the handle 48-3/8" OR a total length of 86" -
whichever is greater.
• Example: For a 6/8 Astragal with a handle height of 36", the minimum astragal length would be 74" (36" + 38" = 74")
Important Notes:
• Pencil/Marker
• Tape Measure
• Chop Saw
Tools Required:
STEP 1: INITIAL PREPARATION
a
. Remove the spine assembly
from the upper half of the
astragal body. Set aside for
reinstallation.
b.
Remove the orange securing
pin from the upper bolt.
d.
Remove the upper trim cap,
and tail cap if present, from the
astragal body.
c.
Slide the drive rods out of the astragal body and
lift the upper bolt out of the astragal. Slide the
drive rods back into the astragal body.
Tail Cap
Optional Parts: