1
Ultimate
Flip Lever
™
Astragal
Cut Down Instructions
8817 West Market Street
Colfax, NC 27235 | 800.334.2006
www.enduraproducts.com
Rev. Date: 05.07.2018
©2017 Endura Products, Inc.
Innovation protected under patents and patents pending in
U.S. and Canada. See www.EnduraPatents.com.
• All cuts should be from the
top of the astragal.
• Ultimate Flip Lever Astragals can be cut down a maximum of 7".
• Bolts should be in the retracted position before beginning.
Notes:
• Pencil/Marker
• Tape Measure
• Chop Saw
• Flathead Screwdriver
• Phillips Screwdriver
Tools Required:
STEP 1: INITIAL PREPARATION
c
. If present, remove the trim strip
from the astragal body.
Y
X
a
. Measure the length of the door panel (X) and the length of
the astragal (Y) on the
narrow edge
.
b
. Round the length of the door panel (X) and the length of the
astragal (Y) down to the closest inch. Subtract the rounded
length of the door panel from the rounded length of the astragal
to determine your
index number.
Example:
To determine index number:
• If the length of the astragal is 79-1/4", round it down to
79
".
• If the length of the door panel is 73-3/4", round it down to
73
".
• 79" - 73" =
6
is the index number.
Tail Cap
Optional Parts:
