EndRun Sonoma N12, User Manual

Page: 99 / 174

S o n o m a U s e r M a n u a l 82
C H A P T E R N I N E
83 S o n o m a U s e r M a n u a l
C O N T R O L A N D S T A T U S C O M M A N D S
Command:
rcvrserialnumber
Sonoma reply:
17080056
rcvrstat
This command is not available in units shipped before June 2017.
It shows three critical status
parameters of the GPS Receiver: the number of satellites currently being tracked, the automatic gain
control DAC value for the receiver front end, and the average Carrier-to-Noise ratio of the tracked
satellites. See Chapter 1 - Introduction, GPS Receivers for information on EndRun’s GPS Receiver.
Command:
rcvrstat
Sonoma reply:
20150622.23:35:50 8 125 45.0
rcvrversion
This command is not available in units shipped before June 2017.
It displays the firmware and
hardware versions of the EndRun GPS Receiver. See Chapter 1 - Introduction, GPS Receivers for
information on EndRun’s GPS Receiver.
Command:
rcvrversion
Sonoma reply:
F/W 6010-0081-000 Ver 1.00 - FPGA 6020-0014-000 Ver 01 - MAR 24 15:05:36 2015
or
rcvrversion: command not found
If the command is not found then your Sonoma does not have an EndRun GPS Receiver.
resetlastgpswn
This command is not available in units shipped before June 2017. It is for use with a GPS simulator.
Not for general use - contact EndRun for details.
resetleaphistory
This command is not available in units shipped before June 2017. It is for use with a GPS simulator.
Not for general use - contact EndRun for details.
serialnumber
This command shows the serial number of the Sonoma. The serial number is not available using this
command for units shipped before August 2015.
Command:
serialnumber
Sonoma reply:
15080056
setantfltmask
This command allows you to enable or mask the GPS antenna fault. Parameter for this command is
either MASKED or ENABLED. Setting this command to MASKED will prevent the antenna fault