EndRun Sonoma N12, User Manual

Page: 86 / 174

S o n o m a U s e r M a n u a l 70
C H A P T E R N I N E
71 S o n o m a U s e r M a n u a l
C O N T R O L A N D S T A T U S C O M M A N D S
Available User Commands
COMMAND FUNCTION
accessconfig Interactive script that guides you in configuring
telnet
,
ssh
and
snmpd
access to the Sonoma that is limited
to specific hosts. The resulting /etc/hosts.allow and
/etc/hosts.deny files are saved to the non-volatile FLASH disk.
Factory default configuration allows access by all hosts.
antfltmask Prints the current setting for the Antenna Fault Mask.
See the
setantfltmask
command.
caldelay Prints the calibration delay. See the
setcaldelay
command.
cpuio
(optional)
Returns the current settings for any installed, user-selectable,
CPU Module options. See
Chapter 10 - Options, CPU Module
Options for more information.
cpuioconfig
(optional)
An interactive utility that allows you to modify the settings
for the CPU Module options. See Chapter 10 - Options, CPU
Module Options
for more information.
cpustat Prints the current Linux CPU core temperature, system load as
percent of maximum and free memory available.
faultstat Prints the summary of all system fault states in a user-friendly
format.
get_sw_opts Returns the current software options enabled in your Sonoma.
See Chapter 10 - Options, Software Options for more informa-
tion.
gpsdynmode Prints the GPS dynamic mode currently in effect.
See the
setgpsdynmode
command.
gpslastfix Prints the last computed GPS position fix.
gpsrefpos Prints the GPS reference position.
See the
setgpsrefpos
command.
gpsstat Prints the GPS Subsystem status information.
gpstrkstat Prints the GPS satellite tracking status. Azimuth, elevation and
signal level (C/No) are shown for each satellite.
gpsutcinfo Prints the GPS UTC Almanac parameters per the GPS-ICD-
200. Also shows the current calculated GPS-UTC offset, which
includes leap seconds and a small sub-second offset.
gpsversion Prints the GPS Subsystem firmware and FPGA version infor-
mation.
help
help command
Prints help for all Sonoma-specific (not Linux) commands.
Prints command-specific help. For example:
help gpsstat
.
inetdconfig Interactive script that allows you to configure the list of pro-
tocol servers which are started by the
inetd
server daemon
running in the Sonoma.
kernelversion Prints the Linux operating system kernel version.
netconfig Interactive script that allows you to configure the IP network
subsystem of the Sonoma.